소개
Nokia Lumia 530 - RM-1017, RM-1019
How to disassemble / take apart the phone and change broken Display or Touch screen Glass Digitizer.
________________________ Video tutorial: ________________________
필요한 것
동영상 개요
-
-
Turn off the phone.
-
Remove the battery and any installed SIM and memory cards. There are two tapes screws:
-
4x Torx T6
-
5x Torx T5
-
Remove the middle bezel.
-
Earpiece
-
Earpiece Flex Cable
-
Loudspeaker / Ringer
-
-
-
If the glass is broken, put some scotch tape to prevent it breake to pieces.
-
Use a hot air to make adhesive tape more soften.
-
Use a cutter and make small room to insert a plastic pick.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 15명이 해당 안내서를 완성하였습니다.
댓글 10개
What did you apply in the first frame of step 7? 4:15 in the video.
Paul Reich - 답글
soldering flux
ZFix -
Thanks for confirming
I didn't end up doing it correctly - it didn't work.
I think the mistake I made was not heating the old flex cable off the connector. I didn't follow instructions correctly and I pulled it off. I was able to heat the leftover connectors off but after soldering the new flex onto the board and sealing up it didnt work - screen still unresponsive :-(
It was my first attempt at replacing a screen (and I don't have any experience) so I'm not too bummed.
I just ordered a complete LCD and digitizer instead :-)
Paul Reich - 답글
Failed miserably... Soldering iron not adapted. Might want to emphasise that is critical. At least I tried...