기기를 수리하세요 커뮤니티 상점

Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement

소개

This repair is very easy; all you need is a T5 Torx Screwdriver, and a new Digitizer Glass & Frame Assebly - it's better to order it with the Front Frame as well, as it makes repairing a lot simpler, and will give your phone a new look and feel.

필요한 것

  1. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement, Touchscreen Glass / Digitizer Assembly: 1 단계, 이미지 1/1

    • The first thing you'll need is a Nokia Lumia 610 with a broken front glass

    편집

  2. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 2 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 2 단계, 이미지 2/2

    • Slide the back cover off, and remove the battery

    편집

  3. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 3 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 3 단계, 이미지 2/2

    • There are 8 Torx 5 screws you have to remove, 4 on each side

    편집

  4. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 4 단계, 이미지 1/3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 4 단계, 이미지 2/3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 4 단계, 이미지 3/3

    • After removing all 8 screws, proceed to prying off the back cover

    • This is done very easily, by prying it from the 3 grooves depicted

    • This step might also be done using your nails, as the clips are not strong at all

    편집

  5. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 5 단계, 이미지 1/1

    • Watch out - the buttons easily fall out; just make sure you don't loose any, a'aight ?!

    편집

  7. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 6 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 6 단계, 이미지 2/2

    • Lift the back cover up, and pull it back - most likely, the 2 sided tape sealing the camera module will be the last thing to break loose

    • Make sure you stick it back to the rear case assembly after this step

    편집

  8. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 7 단계, 이미지 1/3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 7 단계, 이미지 2/3 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 7 단계, 이미지 3/3

    • Disconnect the 2 ribbon cables connecting the LCD & Digitizer to the motherboard

    편집

  9. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 8 단계, 이미지 1/1

    • Now to separate the Motherboard from the front assembly !

    • Gently pry on the 2 hooks depicted in the picture to release the motherboard

    • Again - using your nails should be just fine !

    편집

  10. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 9 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 9 단계, 이미지 2/2

    • Lift the motherboard up from the back, and pull it backwards

    • Apply the same motion as with the back casing

    • You should now have separated the motherboard from the LCD/Digitizer Assembly

    편집

  11. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 10 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 10 단계, 이미지 2/2

    • To detach the LCD, gently lift it from the sides - be careful, and don't pull too hard on the ribbon cable !

    • It's secured in with pretty weak double-sided tape, so this step shouldn't be a problem

    편집

  12. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 11 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 11 단계, 이미지 2/2

    • Remove the ear-piece speaker from the Digitizer Assembly

    • It's held in by - again - pretty weak double-sided tape

    • 2nd picture gives you a look of the front of the speaker unit - it's pretty hard to damage the membrane - though, you can never be too careful !

    편집

  13. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 12 단계, 이미지 1/2 Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 12 단계, 이미지 2/2

    • Something very easy to forget - remove the tiny rubber gasket for the microphone, and place it in the new front panel

    편집

  14. Nokia Lumia 610 Touchscreen Glass / Digitizer Assembly Replacement: 13 단계, 이미지 1/1

    • To put everything back together, just follow the same steps backward, and you should have yourself a good-as-new Nokia Lumia 610

    • The last step in this guide - is trying not to break it again :)

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 6명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 2명과 함께

Darie H

회원 가입일: 11/20/12

4,550 평판

안내서 5개 작성하였습니다

배지: 16

배지 +13개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 2

전체 시간: 5,707