기기를 수리하세요 커뮤니티 상점

OLPC XO-4 Touch Lower Case Replacement

소개

Use this guide to remove and install a new lower case on your OLPC XO-4 Touch.

필요한 것

  1. OLPC XO-4 Touch Lower Case Replacement, Battery: 1 단계, 이미지 1/1

    • Turn the laptop upside-down, with the handle facing away from you.

    번역하기

  2. OLPC XO-4 Touch Lower Case Replacement: 2 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 2 단계, 이미지 2/2

    • Pull the lock tabs towards the green outer edges of the laptop.

    • Hold the left lock tab in the unlock position until the battery is completely removed in the next step.

    번역하기

  3. OLPC XO-4 Touch Lower Case Replacement: 3 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 3 단계, 이미지 2/2

    • Lift up on the middle of the battery to remove it from the device.

    번역하기

  4. OLPC XO-4 Touch Lower Case Replacement, Keyboard: 4 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement, Keyboard: 4 단계, 이미지 2/2

    • Remove the two 2mm Phillips #1 screws from beneath the battery lock tabs.

    번역하기

  5. OLPC XO-4 Touch Lower Case Replacement: 5 단계, 이미지 1/3 OLPC XO-4 Touch Lower Case Replacement: 5 단계, 이미지 2/3 OLPC XO-4 Touch Lower Case Replacement: 5 단계, 이미지 3/3

    • Flip the laptop over to its normal position.

    • Lift the two antennas on both sides to unlock the screen.

    • Open the laptop.

    번역하기

  7. OLPC XO-4 Touch Lower Case Replacement: 6 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 6 단계, 이미지 2/2

    • Be careful not to pull the keyboard too far because there is still a ribbon cable attached to the bottom.

    • Gently lift up on the back of the keyboard.

    • Pull the keyboard up far enough to expose the ribbon cable.

    번역하기

  8. OLPC XO-4 Touch Lower Case Replacement: 7 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 7 단계, 이미지 2/2

    • Gently lift up on the black connector to release the ribbon cable.

    • Gently pull the blue plastic tab up and away from the black connector.

    • Remove the keyboard from the laptop.

    번역하기

  9. OLPC XO-4 Touch Lower Case Replacement, Lower Case: 8 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement, Lower Case: 8 단계, 이미지 2/2

    • Close and flip the laptop over so you are looking at the battery compartment

    • Remove the five 4mm Phillips #1 screws from inside the battery compartment

    번역하기

  10. OLPC XO-4 Touch Lower Case Replacement: 9 단계, 이미지 1/3 OLPC XO-4 Touch Lower Case Replacement: 9 단계, 이미지 2/3 OLPC XO-4 Touch Lower Case Replacement: 9 단계, 이미지 3/3

    • Flip the laptop over, showing the top of the device.

    • Open the laptop and rotate the screen ninety degrees.

    • Tilt the screen so the lower right corner of the screen is closer to the lower case.

    번역하기

  11. OLPC XO-4 Touch Lower Case Replacement: 10 단계, 이미지 1/3 OLPC XO-4 Touch Lower Case Replacement: 10 단계, 이미지 2/3 OLPC XO-4 Touch Lower Case Replacement: 10 단계, 이미지 3/3

    • Push in and lift up on the keyboard edge of the white handle piece.

    • Pull the piece towards yourself to remove it from the laptop.

    번역하기

  12. OLPC XO-4 Touch Lower Case Replacement: 11 단계, 이미지 1/1

    • Remove the four 4mm Phillips #1 screws attaching the green trim to the body of the computer.

    번역하기

  13. OLPC XO-4 Touch Lower Case Replacement: 12 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 12 단계, 이미지 2/2

    • Pry off the rear green trim piece.

    번역하기

  14. OLPC XO-4 Touch Lower Case Replacement: 13 단계, 이미지 1/3 OLPC XO-4 Touch Lower Case Replacement: 13 단계, 이미지 2/3 OLPC XO-4 Touch Lower Case Replacement: 13 단계, 이미지 3/3

    • Be careful not to pull the bottom portion of the laptop completely off, as there is a cable connecting it to the laptop.

    • Slide the green trim pieces away from the screen.

    • This should release the entire bottom portion of the laptop.

    번역하기

  15. OLPC XO-4 Touch Lower Case Replacement: 14 단계, 이미지 1/3 OLPC XO-4 Touch Lower Case Replacement: 14 단계, 이미지 2/3 OLPC XO-4 Touch Lower Case Replacement: 14 단계, 이미지 3/3

    • Unplug the cable from the mouse buttons controller to completely remove the lower frame from the device.

    번역하기

  16. OLPC XO-4 Touch Lower Case Replacement: 15 단계, 이미지 1/2 OLPC XO-4 Touch Lower Case Replacement: 15 단계, 이미지 2/2

    • Rotate the entire lower assembly up slightly, and pull it away from the screen to free it from the screen hinge.

    • There may be some adhesive holding the cable to the metal plate. Gently pull the cable off of the plate if it is stuck.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 6명과 함께

Michael Kellerman

회원 가입일: 01/24/13

58 평판

안내서 3개 작성하였습니다

배지: 9

배지 +6개 더

팀

Cal Poly, Team 3-30, Amido Winter 2013 Cal Poly, Team 3-30, Amido Winter 2013 회원

CPSU-AMIDO-W13S3G30

3 회원들

안내서 12개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 1

30일 전: 2

전체 시간: 337