주요 콘텐츠로 건너뛰기

Olympus D590 Retainer Clip Replacement

필요한 것

  1. Olympus D590 Retainer Clip Replacement, Face Plate: 1 단계, 이미지 1/1
    • Remove five baseplate screws using a Phillips #00 screwdriver.

  2. Olympus D590 Retainer Clip Replacement: 2 단계, 이미지 1/1
    • Press and slide the battery cover retainer clip to the left. Use tweezers to lift the battery cover away.

  3. Olympus D590 Retainer Clip Replacement: 3 단계, 이미지 1/1
    • Remove the single screw from the battery housing using a Phillips #00 screwdriver.

  4. Olympus D590 Retainer Clip Replacement: 4 단계, 이미지 1/1
    • Using tweezers, lift the rubber plate to expose the ports.

  5. Olympus D590 Retainer Clip Replacement: 5 단계, 이미지 1/1
    • Remove two screws from the ports using a Phillips #00 screwdriver.

  6. Olympus D590 Retainer Clip Replacement: 6 단계, 이미지 1/1
    • Use a spudger to pry the faceplate away from the rest of the camera.

  7. Olympus D590 Retainer Clip Replacement: 7 단계, 이미지 1/1
    • To avoid disconnection of the connector line to the motherboard, use caution when pulling faceplate away from camera case.

    • Damage to the connector line will prevent the on/off power switch's operational function.

  8. Olympus D590 Retainer Clip Replacement, Retainer Clip: 8 단계, 이미지 1/1
    • Orient the camera as shown, with the bottom facing up.

    • Open the retainer clip, by using your finger to push down and slide to the left.

    • The clip should pop open.

  9. Olympus D590 Retainer Clip Replacement: 9 단계, 이미지 1/1
    • Hold the retainer clip down (without re-latching it).

    • Use a flathead screwdriver to start to pry out the pin holding the retainer clip's spring to the camera.

  10. Olympus D590 Retainer Clip Replacement: 10 단계, 이미지 1/1
    • Use tweezers to continue to remove the pin.

  11. Olympus D590 Retainer Clip Replacement: 11 단계, 이미지 1/1
    • When it feels loose, pull the pin all the way out with your fingers.

  12. Olympus D590 Retainer Clip Replacement: 12 단계, 이미지 1/1
    • Once the pin comes out, the retainer clip, spring, and pin will no longer be attached to the rest of the camera.

결론

To reassemble your device, follow these instructions in reverse order.

Katie

회원 가입일: 04/15/10

31 평판

안내서 3개 작성하였습니다

Cal Poly, Team 28-23, Regan Spring 2010 Cal Poly, Team 28-23, Regan Spring 2010 회원

CPSU-REGAN-S10S28G23

4 회원들

안내서 14개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 3

전체 시간: 2,140