Onda V701 Speaker Replacement

소개

This guide will show you how to replace a speaker that no longer works. This is a common problem with any electronic device and is an easy fix. Just remember to turn the power off before you begin, and to be careful when using soldering tools.

필요한 것

1 단계 Back Panel

Onda V701 Speaker Replacement, Back Panel: 1 단계, 이미지 1/3

Onda V701 Speaker Replacement, Back Panel: 1 단계, 이미지 2/3

Onda V701 Speaker Replacement, Back Panel: 1 단계, 이미지 3/3

Ensure device is powered off before disassembly.
Remove the 4 rubber screw plugs using a spudger.

번역하기

2 단계

Onda V701 Speaker Replacement: 2 단계, 이미지 3/3

Remove the four 4.8mm mounting screws using a PH00 screwdriver.

번역하기

3 단계

Starting at one corner, gently pry the back panel assembly from the screen assembly using two plastic opening tools.
Slide the opening tools around the perimeter of the device to separate the back panel assembly from the screen assembly.

번역하기

4 단계

Gently lift the screen assembly away from the back cover assembly.
Be careful when separating the two pieces as the screen assembly is still connected to the mother board by two ribbon cables.

번역하기

5 단계

Onda V701 Speaker Replacement: 5 단계, 이미지 3/3

Disconnect the two ribbon connectors by flipping the gray tabs up with a fingernail or a spudger.
Remove the ribbon cables.

번역하기

6 단계 Speaker

Onda V701 Speaker Replacement, Speaker: 6 단계, 이미지 1/2

Onda V701 Speaker Replacement, Speaker: 6 단계, 이미지 2/2

Desolder the black(-) and red(+) wires connecting the speaker to the motherboard using a soldering iron and tweezers to hold the wire.
Soldering requires a lot of heat. Do not touch the metal part of the soldering iron. Wear gloves if necessary to protect your hands. The fumes from soldering could also be toxic. Work in a well ventilated area and/or use a respirator.

번역하기