Skip to main content

소개

This guide shows how to disassemble the Osram Lightify gateway.

  1. Remove the front using a metal spudger.
    • Remove the front using a metal spudger.

    • Once you can get your fingers in, remove the rest using your hand.

  2. On the back of the front cover, remove the white plastic using a metal spudger. Remove the PCB using a spudger
    • On the back of the front cover, remove the white plastic using a metal spudger.

    • Remove the PCB using a spudger

  3. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  4. Once the PCB is removed, use a Torx T9 screwdriver to unscrew and remove the power supply. Remove the screws holding on the back cover with a Torx T9 screwdriver and remove the back cover.
    • Once the PCB is removed, use a Torx T9 screwdriver to unscrew and remove the power supply.

    • Remove the screws holding on the back cover with a Torx T9 screwdriver and remove the back cover.

    • all the screws are the same. they can be mixed with no problem.

  5. Remove the button by grabbing the tab over the button and pulling it out. it will not come out if the button is not depressed. Remove both metal sheets. when its at an angle, push it in a little and then pull it up so that it is pointing straight up. then, you can push it through.
    • Remove the button by grabbing the tab over the button and pulling it out.

    • it will not come out if the button is not depressed.

    • Remove both metal sheets. when its at an angle, push it in a little and then pull it up so that it is pointing straight up. then, you can push it through.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Aiden Baker

회원 가입일: 2015년 09월 19일

12,008 평판

안내서 22개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 95