Oster 3905 Retractable Cord Replacement

소개

If your Oster 3905 cord isn’t retracting like the yo-yo you secretly still use, it may be time to replace it. While this replacement guide is pretty straight forward - watch out! There is a nasty little spring that will try to pop out and blind you.

필요한 것

1 단계 Slot Levers

Oster 3905 Retractable Cord Replacement, Slot Levers: 1 단계, 이미지 1/1

Firmly grip your hand around the slot lever.

편집

2 단계

Stabilize the toaster by placing your hand on top.

편집

3 단계

Forcefully pull the slot lever away from the toaster by keeping parallel to the table.

편집

4 단계

Both slot levers can be removed.

편집

5 단계 Outer Shell

Oster 3905 Retractable Cord Replacement, Outer Shell: 5 단계, 이미지 1/1

Place the toaster upside down so the bottom is facing the ceiling.

편집

6 단계

Take off both rubber feet using a small metal spudger.
Wedge a spudger under the feet and pull up to pop off.

편집

7 단계

Use a PH#2 screw bit to remove eight 12mm screws that are located around the perimeter.
There are two screws under the rubber feet.

편집

8 단계

Place the toaster right side up.

편집

9 단계

Grab the outer shell firmly and pull up towards the face of the toaster.

편집

10 단계

For this part, you might need to wiggle the toaster to get the outer shell off.
The shell will not completely come off until the motherboard is removed in the next step.

편집

11 단계

Oster 3905 Retractable Cord Replacement: 11 단계, 이미지 3/3

Use a J1 screw bit to unscrew eight 8mm screws from the motherboard.

편집

12 단계

Take out the grey “cancel” and “bagel” buttons from the shell.

편집

13 단계 Retractable Cord

Oster 3905 Retractable Cord Replacement, Retractable Cord: 13 단계, 이미지 1/1

Rotate the toaster so that the back is facing towards you.

편집

14 단계

Use the PH#1 bit to remove one 8mm screw located above the wire on the casing.
Then use the same screw bit to remove two 10mm screws found at the bottom.

편집

15 단계

Using the metal spudger, pry next to the black clip found at the base of the toaster and the casing.
Push down to separate the casing from the toaster.

편집

16 단계

Gently tilt the casing towards the toaster as you pull up from the base.

편집

17 단계

Use the PH#1 bit to remove the three 8mm screws located on the back side of the casing.

편집

18 단계

When opening the casing a metal spring may suddenly pop out.
Use the metal spudger to pry open the two halves of the casing.
If you are having some trouble only using the metal spudger do not be afraid of using your fingers to pry the casing apart.