기기를 수리하세요 커뮤니티 상점

Otium Bluetooth Headphones Battery Replacement

소개

The Otium Bluetooth Headphones are rated for 500 charge cycles. If your headphones will not hold charge, or charge at all, you may need to replace the battery.

필요한 것

    • Power off your earbuds first.

    • Use a pry tool to unclip the cover of the left earbud.

    편집

  2. Otium Bluetooth Headphones Battery Replacement: 2 단계, 이미지 1/2 Otium Bluetooth Headphones Battery Replacement: 2 단계, 이미지 2/2

    • Carefully remove the battery from the housing.

    • The battery is connected by two fragile wires.

    • Shown is a 3.7v 100mAh Lithium Polymer (LiPo) battery.

    편집

  4. Otium Bluetooth Headphones Battery Replacement: 3 단계, 이미지 1/2 Otium Bluetooth Headphones Battery Replacement: 3 단계, 이미지 2/2

    • Carefully peel back the rubber cover from the protection circuit module (PCM).

    • Remove the cover and save to re-use.

    • The rubber is attached using Kapton tape and hot glue.

    편집

  5. Otium Bluetooth Headphones Battery Replacement: 4 단계, 이미지 1/2 Otium Bluetooth Headphones Battery Replacement: 4 단계, 이미지 2/2

    • Carefully bend the PCM away from the battery to make desoldering the two wires easier.

    편집

    • Use a soldering iron to desolder the two wires from the PCM.

    • Adding a JST connector would make future repairs much easier!

    • Recycle your old battery!

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 1명과 함께

Geralt

회원 가입일: 11/28/14

1,789 평판

안내서 1개 작성함

배지: 16

배지 +13개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 10

30일 전: 60

전체 시간: 753