PSP 300xc Power Switch Board Replacement
Has the power switch broken on your precious PSP 300xc? Replace the power switch board, and set everything right once more.
-
-
Press the button securing the battery door to the PSP 300xc, and lift the battery door off.
-
Lift the battery out of the PSP.
-
-
-
Use a spudger or your fingernail to remove the warranty sticker stuck to the inside of the battery tray
-
-
-
-
Rotate the LCD away from the PSP to reveal the LCD and home bar ribbon cables.
-
Use your fingernail or the edge of a plastic opening tool to flip up the retaining flap on the following four ZIF connectors:
-
Home bar cable
-
Microphone cable
-
LCD display data cable
-
Touchscreen cable
-
After flipping up the locking tabs on all four connectors, use your fingers or a spudger to gently pull the cables straight out of the connectors.
-
-
-
Lift the home bar up as high as it will go, but not so high that the wires disconnect.
-
Twist the home bar counter clockwise while carefully lifting it further. The left edge has to lift over the black plastic frame to allow it to rotate.
-
The home bar should now lift out of the PSP 300xc.
-
-
-
Using a finger or spudger, flip up the retaining flap on the power switch board ribbon cable socket.
-
Pull the ribbon cable out of its socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 한 분이 해당 안내서를 완성하였습니다.
