소개

Installing a new motherboard assembly which contains the processor and software package.

부품

부품은 필요하지 않습니다.

  1. Place the Palm IIIx face down on a flat surface.
    • Place the Palm IIIx face down on a flat surface.

    댓글 쓰기

  2. Push down, lift up on, and remove battery cover.
    • Push down, lift up on, and remove battery cover.

    댓글 쓰기

    • Remove the old batteries one at a time.

    댓글 쓰기

    • Using a Phillips #00 screwdriver, remove the four screws that hold the back cover in place.

    댓글 쓰기

    • Hold the device on its side, positioning your hands as shown.

    • Remove the back cover by pushing in with your thumbs and pulling outward with the rest of your fingers.

    댓글 쓰기

    • Hold the screen and front cover on its side, facing the screen inward as shown.

    • Position your hands so that you can push the screen outward with your thumbs.

    • Remove the screen by pushing outward with your thumbs. Use your index fingers to hold the front cover in place.

    댓글 쓰기

    • Position the device with the screen facing down.

    • Locate the white ribbon wire on the left hand side of the device.

    • On either side of the ribbon wire are two white clasps. Gently push the two clasps away from the board (to the left).

    댓글 쓰기

    • Detach the ribbon wire by gently pulling it out of its connector.

    댓글 쓰기

    • Separate the motherboard from the screen.

    댓글 쓰기

    • Now the motherboard assembly can be replaced successfully.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Ben Johnson

회원 가입일: 2010년 01월 26일

22 평판

안내서 1개 작성함

Cal Poly, Team 14-43, Regan Winter 2010 Cal Poly, Team 14-43, Regan Winter 2010 회원

CPSU-REGAN-W10S14G43

5 회원들

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 1

지난 30일: 2

전체 시간: 2,714