주요 콘텐츠로 건너뛰기

소개

This is a repair guide to access and replace the LCD screen.

  1. Position the phone so the screen faces down.
    • Position the phone so the screen faces down.

    • Remove the stylus found on the back of the phone.

  2. To remove the battery cover, hold down the button in the middle of the phone's back.
    • To remove the battery cover, hold down the button in the middle of the phone's back.

    • Slide the cover down to remove it, and set the cover aside.

  3. Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
    • Lift the edge of the battery, separating contact points, and pull out as pictured.

  4. Remove the round rubber cover on the back of the phone located immediately below the antenna.
    • Remove the round rubber cover on the back of the phone located immediately below the antenna.

    • This will uncover a screw that will be removed in the next step.

  5. Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver. Remove the single 9.8 mm screw next to the antenna on the back plate using a Phillips #00 screwdriver.
    • Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver.

    • Remove the single 9.8 mm screw next to the antenna on the back plate using a Phillips #00 screwdriver.

  6. Remove the antenna.
    • Remove the antenna.

  7. Pry the back cover off using an iFixIt opening tool. The back cover is attached by several small clips on the inside.
    • Pry the back cover off using an iFixIt opening tool.

    • The back cover is attached by several small clips on the inside.

  8. Disconnect the ribbon cable before removing the motherboard. Unclip the gray tab. Pull out the orange ribbon cable.
    • Disconnect the ribbon cable before removing the motherboard.

    • Unclip the gray tab.

    • Pull out the orange ribbon cable.

  9. Pull off the motherboard. Pull off the motherboard.
    • Pull off the motherboard.

  10. Lift up the LCD screen so that the ribbon strip connecting it to the motherboard can be accessed. Only lift the screen high enough to access the ribbon cable. Only lift the screen high enough to access the ribbon cable.
    • Lift up the LCD screen so that the ribbon strip connecting it to the motherboard can be accessed.

    • Only lift the screen high enough to access the ribbon cable.

  11. Unclip the gray tab. Pull out the orange ribbon strip.
    • Unclip the gray tab.

    • Pull out the orange ribbon strip.

    • Remove the LCD screen.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

cgood

회원 가입일: 2009년 10월 28일

122 평판

안내서 7개 작성하였습니다

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009 회원

CPSU-MANESS-F09S19G3

4 회원들

안내서 18개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 2

전체 시간: 4,997