주요 콘텐츠로 건너뛰기

Palm m 100 Cover Replacement

필요한 것

  1. Palm m 100 Cover Replacement, Cover: 1 단계, 이미지 1/1
    • Remove the batteries.

  2. Palm m 100 Cover Replacement: 2 단계, 이미지 1/1
    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

  3. Palm m 100 Cover Replacement: 3 단계, 이미지 1/3 Palm m 100 Cover Replacement: 3 단계, 이미지 2/3 Palm m 100 Cover Replacement: 3 단계, 이미지 3/3
    • Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

  4. Palm m 100 Cover Replacement: 4 단계, 이미지 1/1
    • Set aside broken cover, and replace with a new cover.

  5. Palm m 100 Cover Replacement: 5 단계, 이미지 1/1
    • Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

  6. Palm m 100 Cover Replacement: 6 단계, 이미지 1/1
    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

결론

To reassemble your device, follow these instructions in reverse order.

Anne Carey

회원 가입일: 10/25/11

1 평판

안내서 3개 작성하였습니다

James Madison, Team 1-3, Allen Fall 2011 James Madison, Team 1-3, Allen Fall 2011 회원

JMU-ALLEN-F11S1G3

5 회원들

안내서 5개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 537