기기를 수리하세요 커뮤니티 상점

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

PalmOne Zire 72 Motherboard Replacement

필요한 것

  1. PalmOne Zire 72 Motherboard Replacement, Motherboard: 1 단계, 이미지 1/2 PalmOne Zire 72 Motherboard Replacement, Motherboard: 1 단계, 이미지 2/2

    • Using a T5 Torx screwdriver, unscrew the two 5mm screws located at the bottom of the device.

    번역하기

  2. PalmOne Zire 72 Motherboard Replacement: 2 단계, 이미지 1/1

    • Peel back the adhesive label below the camera on the rear to reveal a hidden screw, circled in the picture to the left.

    • If you peel the entire label off, two holes underneath will be exposed to future damage. Try to preserve the label to reapply later.

    • Alternate Procedure: Underneath the camera, feel for a depression and cut the sticker directly above the depression to reveal the hidden screw.

    번역하기

  3. PalmOne Zire 72 Motherboard Replacement: 3 단계, 이미지 1/1

    • Use a #00 Philips screwdriver to remove the 2.5mm hidden screw.

    번역하기

  4. PalmOne Zire 72 Motherboard Replacement: 4 단계, 이미지 1/1

    • Use either end of the spudger to carefully pry off the camera lens mesh cover.

    번역하기

  5. PalmOne Zire 72 Motherboard Replacement: 5 단계, 이미지 1/1

    • Using the #00 Phillips screwdriver, remove the two 9mm screws on the top corners of the device.

    번역하기

  7. PalmOne Zire 72 Motherboard Replacement: 6 단계, 이미지 1/2 PalmOne Zire 72 Motherboard Replacement: 6 단계, 이미지 2/2

    • Spin the phone around so that the headphone jack is facing you. Run the flat end of the spudger around the entire edge of the device to gently pry the case off.

    • Gently remove the case to avoid damaging it. Do not try to force the case open.

    • The L shaped latches located on the bottom of the device make it hard to remove the case; you should run the spudger around the device's edges again if you are having problems.

    번역하기

  8. PalmOne Zire 72 Motherboard Replacement: 7 단계, 이미지 1/2 PalmOne Zire 72 Motherboard Replacement: 7 단계, 이미지 2/2

    • Remove the cover by lifting it from right to left.

    • This should be similar to the action of the opening of a book.

    • The brown film connecting the motherboard to the screen may tear if this is not done carefully.

    번역하기

  9. PalmOne Zire 72 Motherboard Replacement: 8 단계, 이미지 1/1

    • Lift the control pad buttons off of the motherboard.

    번역하기

  10. PalmOne Zire 72 Motherboard Replacement: 9 단계, 이미지 1/1

    • Wedge the flat end of the spudger underneath the battery and gently pry it out.

    • Be wary of the red and black wires on the battery, which may rip easily.

    • The battery may have adhesive holding it to the device.

    • The battery connector may rip if the battery is not removed carefully.

    번역하기

  11. PalmOne Zire 72 Motherboard Replacement: 10 단계, 이미지 1/1

    • Gently disconnect the white component connecting the battery to the motherboard.

    • The connector should be pulled upward.

    번역하기

  12. PalmOne Zire 72 Motherboard Replacement: 11 단계, 이미지 1/1

    • Unscrew the single 3.5mm screw attaching the motherboard to the case with a #00 Phillips screwdriver.

    번역하기

  13. PalmOne Zire 72 Motherboard Replacement: 12 단계, 이미지 1/2 PalmOne Zire 72 Motherboard Replacement: 12 단계, 이미지 2/2

    • Disconnect the orange video connector leading from the lower case to the upper case with the pointed end of the spudger.

    • The orange video connector is the cable that connects the motherboard to the screen.

    번역하기

  14. PalmOne Zire 72 Motherboard Replacement: 13 단계, 이미지 1/3 PalmOne Zire 72 Motherboard Replacement: 13 단계, 이미지 2/3 PalmOne Zire 72 Motherboard Replacement: 13 단계, 이미지 3/3

    • Disconnect the camera from the motherboard. There are 1.5mm gaps on either side of the connector between the connector and its port. Put the pointed end of the spudger in one gap at a time and "walk" the connector out by wedging out the connector on each side.

    • If it is difficult to pry out the connector completely with the spudger, you may remove it by hand.

    번역하기

  15. PalmOne Zire 72 Motherboard Replacement: 14 단계, 이미지 1/1

    • Using the spudger, pry the motherboard off of the device.

    • We recommend removing the motherboard off of the device from left to right.

    번역하기

  16. PalmOne Zire 72 Motherboard Replacement: 15 단계, 이미지 1/2 PalmOne Zire 72 Motherboard Replacement: 15 단계, 이미지 2/2

    • Feed the video connector from the camera through the square hole in the motherboard.

    • After doing so, you may carefully lift the motherboard out of the back case.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 5명과 함께

Michelle Medina

회원 가입일: 04/10/12

63 평판

안내서 5개 작성하였습니다

배지: 9

배지 +6개 더

팀

Cal Poly, Team 6-49, Amido Spring 2012 Cal Poly, Team 6-49, Amido Spring 2012 회원

CPSU-AMIDO-S12S6G49

4 회원들

안내서 11개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 4

전체 시간: 867