소개

This guide will show you how to locate and replace the fan in the PlayStation 2 Slimline.

부품

부품은 필요하지 않습니다.

  1. Disconnect all cables from the console and flip the unit over to reveal its base.
    • Disconnect all cables from the console and flip the unit over to reveal its base.

    댓글 쓰기

  2. Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.
    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

    댓글 쓰기

    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

    댓글 쓰기

    • Locate the fan at the front, left section of the unit.

    댓글 쓰기

    • Peel off the sticker holding the power cords to the unit.

    댓글 쓰기

    • Lift the connector from the motherboard with a pair of tweezers using a firm, upward force.

    댓글 쓰기

    • Remove all three 1.6 mm screws fastening the fan to the unit using a #1 Phillips screwdriver.

    • Gently lift and remove the fan from its compartment.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 6명이 해당 안내서를 완성하였습니다.

Thomas Sullivan

회원 가입일: 2013년 10월 23일

2,238 평판

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 5

지난 7일: 14

지난 30일: 28

전체 시간: 2,525