소개

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

  1. Move film door slide on the left side of camera forward.
    • Move film door slide on the left side of camera forward.

    • Pull film door open.

    댓글 쓰기

  2. Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.
    • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

    • If your camera is old or dirty, it may take more force to open the flash assembly.

    댓글 쓰기

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a spudger on each side to separate the flash segment from the main body.

    • Be careful not to do this too hard because you may pull out the connecting wires.

    댓글 쓰기

    • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

    댓글 쓰기

    • Place left hand on the gray section and right hand on the black section.

    • Pull the sections apart.

    댓글 쓰기

    • Carefully remove the damaged lens from the interior of the camera.

    • Replace with a new lens.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Ian Hosek

회원 가입일: 2010년 01월 20일

345 평판

안내서 1개 작성함

Cal Poly, Team 3-18, Maness Winter 2010 Cal Poly, Team 3-18, Maness Winter 2010 회원

CPSU-MANESS-W10S3G18

4 회원들

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 5

지난 30일: 49

전체 시간: 7,791