소개

Install an Airport Extreme 802.11g card internally.

Use a coin to turn the battery locking screw 90 degrees to the right.
  • Use a coin to turn the battery locking screw 90 degrees to the right.

  • Lift the battery out of the computer.

What can I say?

It is certainly do able. I just completed it. Took me 2 hours. The most important tool you'll need is patience - bag full of patience!!

Gopal - 답글

Took 3 1/2 to 4 hours for someone who is handy but has never opened a computer before. Not so bad and it was a fun learning experience.

Nomad Toes - 답글

Nomad Toes로 부터 인용:

Took 3 1/2 to 4 hours for someone who is handy but has never opened a computer before. Not so bad and it was a fun learning experience.

Weird. I posted this on Step 1 of replacing the optical drive, but it showed up on the RAM page since Step 1 is the same. Replacing the RAM takes 10 minutes.

Nomad Toes - 답글

Flip down the door on the right side of the battery compartment.
  • Flip down the door on the right side of the battery compartment.

댓글 쓰기

  • Use a spudger or flathead screwdriver to disconnect the Airport antenna from the card.

Note that this is a "right angle" coaxial connector. The metal cube is a part of the connector and stays with the cable. It is not a part of the airpor card. Also, I found two clear plastic blocks in front of the airport card, a smaller one near the connector and a larger one on the other side. Possibly these are to keep the cable from vibrating and flexing during, say, a truck ride. Don't lose these.

jerrykrinock - 답글

  • Grasp the plastic tab and pull the card out all the way.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 20명이 해당 안내서를 완성하였습니다.

첨부 문서

iRobot

회원 가입일: 2009년 09월 24일

1 평판

안내서 774개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 16

전체 시간: 19,562