기기를 수리하세요 커뮤니티 상점

Protocol Galileo Stealth Housing Replacement

소개

This guide will walk you through how to separate the upper and lower housing units of the drone. Minimal tooling is required; however, prerequisite steps are required. This guide is useful for accessing internal components of the drone.

필요한 것

  1. Protocol Galileo Stealth Housing Replacement, Propeller: 1 단계, 이미지 1/1

    • Remove the chrome shaft cover by lightly pulling it away from the drone.

    번역하기

  2. Protocol Galileo Stealth Housing Replacement: 2 단계, 이미지 1/1

    • Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

    • Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

    번역하기

  4. Protocol Galileo Stealth Housing Replacement: 3 단계, 이미지 1/1

    • Remove the propeller stop from shaft by lightly pulling it away from the drone.

    번역하기

  5. Protocol Galileo Stealth Housing Replacement: 4 단계, 이미지 1/1

    • Remove the propeller from shaft by lightly pulling it away from the drone.

    번역하기

  6. Protocol Galileo Stealth Housing Replacement, Housing: 5 단계, 이미지 1/2 Protocol Galileo Stealth Housing Replacement, Housing: 5 단계, 이미지 2/2

    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

    번역하기

  7. Protocol Galileo Stealth Housing Replacement: 6 단계, 이미지 1/1

    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 3명과 함께

Matthew Selting

회원 가입일: 02/15/18

432 평판

안내서 4개 작성하였습니다

배지: 6

배지 +3개 더

팀

UW Stout, Team S8-G4, Ogden Spring 2018 UW Stout, Team S8-G4, Ogden Spring 2018 회원

UWSTOUT-OGDEN-S18S8G4

4 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 1

전체 시간: 125