Protocol Galileo Stealth Light Emitting Diode (LED) Replacement

소개

This guide will walk you through how to replace the light emitting diodes (LED) on the drone. Minimal tooling is required, but the risk of damaging the drone is greater then many of the other guides if each step is not followed and executed with extra care.

필요한 것

1 단계 Housing

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: 1 단계, 이미지 1/2

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Housing: 1 단계, 이미지 2/2

Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.
Take care to place the screws in a safe place to prevent losing them.

번역하기

2 단계

Separate the upper and lower housing units by lightly pulling the two housing units apart.

번역하기

3 단계 Light Emitting Diode (LED)

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement, Light Emitting Diode (LED): 3 단계, 이미지 1/1

Remove 6mm Phillips #0 screw from the LED strip.

번역하기

4 단계

Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.
Take care not to damage the LED strip when removing it from the lower housing.

번역하기

5 단계

Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.
Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.

번역하기