주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

Follow these steps to disassemble the plastic casing of the RIDGID R84015 X2 power drill.

  1. Remove the backplate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  3. Remove the gear casing from the body. Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

  4. With your drill taken apart, move your attention to the trigger and forward reverse switch.
    • With your drill taken apart, move your attention to the trigger and forward reverse switch.

  5. Check to see that the forward reverse switch isn't broken.
    • Check to see that the forward reverse switch isn't broken.

    • NOTE: small tab on trigger fits into groove on forward reverse switch

  6. With the battery attached, check that the wires work when the trigger is pulled.
    • With the battery attached, check that the wires work when the trigger is pulled.

    • Put multimeter wires here.

    • If wires work and drill doesn't, the problem is with the motor.

  7. Make sure plastic is not broken and switch is not stuck.
    • Make sure plastic is not broken and switch is not stuck.

결승점

다른 2명이 해당 안내서를 완성하였습니다.

Brian

회원 가입일: 2010년 04월 12일

97 평판

안내서 1개 작성함

Cal Poly, Team 15-48, Garner Spring 2010 Cal Poly, Team 15-48, Garner Spring 2010 회원

CPSU-GARNER-S10S15G48

6 회원들

안내서 10개 작성하였습니다

I was able to diagnose and fix my problem with my black and decker following your instructions. TY

boxingchaos2011 - 답글

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 14

30일 전: 49

전체 시간: 11,959