RazorX DLX Electric Skateboard Power Button Replacement

소개

This guide is intended to show you how to replace the power button on the RazorX DLX Electric Skateboard. The power button is a temporary switch that allows the battery to supply power to the motor. The power button is necessary to ensure safety and longevity of the battery itself. While troubleshooting be careful when handling wires and the circuit board. Before you start, make sure the device is powered off.

필요한 것

1 단계 Battery

RazorX DLX Electric Skateboard Power Button Replacement, Battery: 1 단계, 이미지 3개 중 1개

RazorX DLX Electric Skateboard Power Button Replacement, Battery: 1 단계, 이미지 3개 중 2개

RazorX DLX Electric Skateboard Power Button Replacement, Battery: 1 단계, 이미지 3개 중 3개

Flip the skateboard upside down.
Use a 4 mm Allen key to remove the 25 mm bolt that secures the cover.
Push the cover forward to slide it off.

편집

2 단계

Disconnect the battery and slide it out.
Lithium-ion batteries should not be punctured, heated or improperly disposed of.

편집

3 단계 Control Module

RazorX DLX Electric Skateboard Power Button Replacement, Control Module: 3 단계, 이미지 3개 중 1개

RazorX DLX Electric Skateboard Power Button Replacement, Control Module: 3 단계, 이미지 3개 중 2개

RazorX DLX Electric Skateboard Power Button Replacement, Control Module: 3 단계, 이미지 3개 중 3개

Flip the skateboard back over.
Remove the six 22 mm bolts indicated on the top side of the skateboard with a 3 mm Allen key.
While holding the nut from the underside of the skateboard remove the four 32 mm bolts with the 3 mm Allen key.
Separate the trucks and control module from the board.

편집

4 단계

RazorX DLX Electric Skateboard Power Button Replacement: 4 단계, 이미지 3개 중 3개

Remove the four 20 mm bolts using a 4 mm Allen key, then remove the metal plate to separate the motor from the trucks.
Separate the wheel motor from the trucks

편집

5 단계

Remove the two 15 mm Phillips #00 screws to free the motor cable.
Remove the two 15 mm Phillips #00 screws securing the battery cage.
You will still need to remove the standoffs to fully remove the battery cage.

편집

6 단계

RazorX DLX Electric Skateboard Power Button Replacement: 6 단계, 이미지 3개 중 3개

Remove the two standoffs holding the battery cage in place with an 8 mm wrench.
The standoffs have a nylon washer on either side of the battery cage.
Lift the battery cage up and out of the control module.

편집

7 단계

RazorX DLX Electric Skateboard Power Button Replacement: 7 단계, 이미지 3개 중 3개

Remove the 20 mm Phillips #0 screw.
Disconnect the DC connector. The DC connector can be identified as the connector with only two wires.
Disconnect the power button. It is a temporary switch, which can be identified by its 4-wire configuration.
Disconnect the Hall effect sensor. It can be identified by its 6-wire configuration.
A hall effect sensor is used to tell the board where the motor is in its rotation.
You will need to remove silicone and hot glue to remove the connectors.