소개

To begin, make sure to remove the battery before doing anything else.

Make sure that the computer is turned off and is disconnected from external power source.
  • Make sure that the computer is turned off and is disconnected from external power source.

  • Turn it upside down and locate the battery release switch.

Introduction: Parts: Need to add the Fan Part Numbers

Original equipment: CPU Fan DC28A000820, GPU Fan DC28A000920

John Frazier - 답글

While holding the switch in the open position, lift out the battery.
  • While holding the switch in the open position, lift out the battery.

  • If you plan to work on any internal laptop components, press and hold the power button for 5 seconds. This will dissipate any residual charge on the motherboard to prevent electrical shock when you begin to handle it.

댓글 쓰기

  • Remove the two Phillips #1 screws on the left side of the computer, just above the battery compartment.

  • These screws hold the hard drive tray into the hard drive compartment.

댓글 쓰기

  • Slide the hard drive tray out of the hard drive compartment.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Malik Shahbal

회원 가입일: 2010년 10월 05일

429 평판

안내서 6개 작성하였습니다

Cal Poly, Team 22-5, Maness Fall 2010 Cal Poly, Team 22-5, Maness Fall 2010 회원

CPSU-MANESS-F10S22G5

4 회원들

안내서 11개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 3

지난 7일: 10

지난 30일: 32

전체 시간: 17,925