소개

After you remove the back cover, you can get to any part of your RoadMate.

부품

부품은 필요하지 않습니다.

  1. Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.
    • Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.

    • Please note: this is a tedious process, but be patient.

    댓글 쓰기

  2. Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.
    • Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Open the back cover.

    • Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.

    댓글 쓰기

    • Disconnect the speaker from the terminal.

    • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

    In my 1200, the speaker is glued to the back and soldered into the board so there is no plug to undo. Just carefully find a position so that board doesn't pull on the speaker wire while it is open.

    Jomar - 답글

    where can we get the speakers from? please

    bbunni1404 - 답글

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Ross Light

회원 가입일: 2010년 04월 12일

175 평판

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 3,284