Repairing a Panasonic SA-HT810V with the H02/H07 error

1 단계 Repairing a Panasonic SA-HT810V with the H02/H07 error




• With the front display of the device facing you, rotate the device 90 degrees counter clockwise.
• Remove the screw that is on the right side of the panel facing you.
• Now rotate the device 180 degrees and remove the second screw.
• Remove all screws with a phillips head screwdriver.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
2 단계



• Rotate the device so that the back faces you.
• With a phillips head screwdriver, locate and remove the two screws highlighted by the red circles in image one.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
3 단계
• Before removing top cover make sure that the back of the device is facing you.
• Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.
편집
댓글 달기
댓글 달기
댓글 쓰기
1024
취소 댓글 달기
4 단계
• Note that the spindle you will be lubing is located underneath the white disk device highlighted in figure one
• Tilt the device on its front side until you can see underneath the white circular component mentioned in the note above.
• Locate the spindle circled in figure two and apply one or two drops of 3 in 1 lubricating oil to the spindle.
편집
댓글 한 개
댓글 달기
댓글 쓰기
1024
취소 댓글 달기

작성자

다른 기여자 5명과 함께

Nathan Cheadle

회원 가입일: 04/15/10

161 평판

안내서 7개 작성하였습니다

Badges: 10

• 
• 
• 

배지 +7개 더

팀

Cal Poly, Team 16-5, Maness Spring 2010 Cal Poly, Team 16-5, Maness Spring 2010 회원

CPSU-MANESS-S10S16G5

4 회원들

안내서 7개 작성하였습니다

해당 안내서 퍼가기

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

미리보기