기기를 수리하세요 커뮤니티 상점

Ryobi RJ1861V Saw Bar Assembly Replacement

소개

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

필요한 것

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: 1 단계, 이미지 1/1

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

    편집

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: 2 단계, 이미지 1/2 Ryobi RJ1861V Saw Bar Assembly Replacement: 2 단계, 이미지 2/2

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

    편집

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: 3 단계, 이미지 1/1

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

    편집

  4. Ryobi RJ1861V Saw Bar Assembly Replacement: 4 단계, 이미지 1/1

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

    편집

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: 5 단계, 이미지 1/1

    • Remove the backside panel.

    편집

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: 6 단계, 이미지 1/1

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

    편집

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: 7 단계, 이미지 1/1

    • Lift the assembly bar up and out of the chassis.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 5명과 함께

Ryan Quinlivan

회원 가입일: 04/08/19

306 평판

안내서 2개 작성하였습니다

배지: 4

+1개 배지 추가

팀

Eastern Washington University, Team S25-G2, Crane Spring 2020 Eastern Washington University, Team S25-G2, Crane Spring 2020 회원

EWU-CRANE-S20S25G2

4 회원들

안내서 3개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 7

30일 전: 30

전체 시간: 869