기기를 수리하세요 커뮤니티 상점

SG 552-1 Commando Gearbox Replacement

소개

This guide will be showing step-by-step instructions on how to get to and replace the gearbox of the airsoft gun.

필요한 것

  1. SG 552-1 Commando Gearbox Replacement, Gearbox: 1 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement, Gearbox: 1 단계, 이미지 2/2

    • Using a flathead screwdriver, remove the pin holding the hand guard in place.

    • To remove this, turn the pin clockwise and push it through at the same time.

    • Remove the hand guard.

    편집

  2. SG 552-1 Commando Gearbox Replacement: 2 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 2 단계, 이미지 2/2

    • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun.

    • There should be four total.

    편집

  3. SG 552-1 Commando Gearbox Replacement: 3 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 3 단계, 이미지 2/2

    • Turn the gun over so that you are facing the bottom of the gun.

    • Using a Phillips #1 screwdriver, remove the following screws:

    • Remove the 8mm screw that is located directly underneath the cocking lever.

    • Remove the 8mm screw located beside the screw you just removed.

    편집

  4. SG 552-1 Commando Gearbox Replacement: 4 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 4 단계, 이미지 2/2

    • Carefully tug on the tip of the gun and pull the barrel and its cover out.

    편집

  6. SG 552-1 Commando Gearbox Replacement: 5 단계, 이미지 1/3 SG 552-1 Commando Gearbox Replacement: 5 단계, 이미지 2/3 SG 552-1 Commando Gearbox Replacement: 5 단계, 이미지 3/3

    • Locate the hand grip.

    • Using a Phillips #0 screwdriver, remove the two 6mm screws at the bottom of the hand grip.

    • Slide the cover off.

    편집

  7. SG 552-1 Commando Gearbox Replacement: 6 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 6 단계, 이미지 2/2

    • Pull the motor out of the hand grip.

    • Using a Phillips #1 screwdriver, remove the two 5mm screws inside of the hand grip.

    편집

  8. SG 552-1 Commando Gearbox Replacement: 7 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 7 단계, 이미지 2/2

    • Locate the pin holding the folding stock in place.

    • Using an allen wrench or something small, carefully push the pin out.

    편집

  9. SG 552-1 Commando Gearbox Replacement: 8 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 8 단계, 이미지 2/2

    • Using a Phillips #1 screwdriver, remove the 20mm screw behind the folding stock and above the gearbox.

    • Remove the cover that was held on by the screw.

    편집

  10. SG 552-1 Commando Gearbox Replacement: 9 단계, 이미지 1/3 SG 552-1 Commando Gearbox Replacement: 9 단계, 이미지 2/3 SG 552-1 Commando Gearbox Replacement: 9 단계, 이미지 3/3

    • Using a flathead screwdriver, remove the two 5mm screws beside the safety switch on both sides of the gun.

    • Slide off the piece that was held on by those screws.

    편집

  11. SG 552-1 Commando Gearbox Replacement: 10 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 10 단계, 이미지 2/2

    • Using a small allen wrench, carefully unscrew the screws holding the safety switch in place on both sides of the gun.

    • The screws do not have to be taken out all the way, just slightly loosen them until you are able to pull the switch off.

    편집

  12. SG 552-1 Commando Gearbox Replacement: 11 단계, 이미지 1/2 SG 552-1 Commando Gearbox Replacement: 11 단계, 이미지 2/2

    • Using a Phillips #0 screwdriver, remove the two 6mm screws that were underneath the safety switch on both sides of the gun.

    • Carefully remove the pieces that were held on by the screws.

    편집

  13. SG 552-1 Commando Gearbox Replacement: 12 단계, 이미지 1/3 SG 552-1 Commando Gearbox Replacement: 12 단계, 이미지 2/3 SG 552-1 Commando Gearbox Replacement: 12 단계, 이미지 3/3

    • Pull apart the cover when pulling the gearbox out.

    • Pull the gearbox out.

    • The gears will fall out when taking the gearbox out. Careful not to lose them.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 4명과 함께

Amanda Toan

회원 가입일: 10/05/12

283 평판

안내서 1개 작성함

배지: 8

배지 +5개 더

팀

Cal Poly, Team 18-41, Regan Fall 2012 Cal Poly, Team 18-41, Regan Fall 2012 회원

CPSU-REGAN-F12S18G41

6 회원들

안내서 6개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 1

30일 전: 5

전체 시간: 2,532