기기를 수리하세요 커뮤니티 상점

SOMNOcomfort and SOMNObalance Ventilator Fan Replacement

의료 장비
iFixit과 이 수리 안내서는 의료 기기 제조업체가 보증하지 않으며 제휴 관계가 없습니다.

소개

Reference page 28-30 from the Service and Repair Instructions linked under Documents on the Main Page.

필요한 것

  1. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement, How to Open and Close Housing (SOMNOcomfort and SOMNObalance Ventilator): 1 단계, 이미지 1/1

    • Remove the covering cap. (pg. 23)

    번역하기

  2. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 2 단계, 이미지 1/1

    • Place the unit upside down on a non-slip surface and remove the six screws. (pg. 23)

    번역하기

  3. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 3 단계, 이미지 1/1

    • Remove the lower part of the housing with a swiveling motion away to the side. Note the SOMNOcomfort series uses a shorter circuit board than the balance series ventilator. (pg. 23)

    번역하기

  4. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 4 단계, 이미지 1/3 SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 4 단계, 이미지 2/3 SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 4 단계, 이미지 3/3

    • Remove the connector (X1) from the circuit board.

    • Pull the connecting cable (64) from its mount.

    • Now set aside the lower part of the housing. (pg. 23)

    번역하기

  5. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 5 단계, 이미지 1/2 SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 5 단계, 이미지 2/2

    • Next, how to close the compartment and reverse the process.

    • Hold the lower part of the housing to the upper part at an angle

    • Attach the connector (X1) to the main circuit board. When doing so the connector’s nub has to point towards the lock. (pg. 24)

    번역하기

  6. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 6 단계, 이미지 1/2 SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 6 단계, 이미지 2/2

    • Properly align the main circuit board inside the unit.

    • Attach the connecting cable (64) to its mount (pg. 24)

    번역하기

  7. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 7 단계, 이미지 1/1

    • Place the lower part of the housing on the upper part (47). Please make sure the main circuit board (44) is aligned properly, and that the connecting cable (64) is not being squeezed anywhere. (pg. 24)

    번역하기

  8. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 8 단계, 이미지 1/1

    • Now reattach the upper part of the housing by tightening the six screws. (pg. 24)

    번역하기

  9. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 9 단계, 이미지 1/1

    • Insert the covering cap. (pg. 24)

    번역하기

  10. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement, Fan: 10 단계, 이미지 1/1

    • Remove baffle box.

    번역하기

  11. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 11 단계, 이미지 1/2 SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 11 단계, 이미지 2/2

    • Remove the decoupling tube(50) from the box.

    번역하기

  12. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 12 단계, 이미지 1/1

    • Remove the box(53) in an upwards motion. Leave the Foam bottom (59) attached.

    번역하기

  13. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 13 단계, 이미지 1/1

    • Remove the four screws (69) in the cover of the baffle box (60).

    • Remove the foam cover (58) and the cover of the baffle box (60).

    번역하기

  14. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 14 단계, 이미지 1/1

    • Remove the foam bottom and separate the two parts of the baffle box.

    번역하기

  15. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 15 단계, 이미지 1/1

    • Pull the decoupling tube(55) out of the motor frame’s borehole7.

    번역하기

  16. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 16 단계, 이미지 1/1

    • Loosen the motor mount(54). Cut the mount using scissors or scalpel.

    • Remove the Fan.

    번역하기

  17. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 17 단계, 이미지 1/1

    • Place three new motor mounts(54) into the box.

    번역하기

  18. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 18 단계, 이미지 1/1

    • Insert the fan into the motor frame and attach it using the motor mounts(54). Pull the motor mounts through the boreholes of the fan to reach the surrounding notch.

    번역하기

  19. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 19 단계, 이미지 1/1

    • Apply a small amount of 70% Isopropanol solution on the decoupling tube’s(55) circumference and attach it to the box. The tube’s notch must completely lock into the bore hole rim.

    번역하기

  20. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 20 단계, 이미지 1/1

    • Reconnect the two parts of the box. Pay attention to the proper alignment of the foam part (61) and the correct cable lead. The cable must be placed in the appropriate cut-out.

    번역하기

  21. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 21 단계, 이미지 1/1

    • Place the cover on the box and insert the screws.

    번역하기

  22. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 22 단계, 이미지 1/1

    • Insert Baffle Box. Place foam 58on the box, soft side up. You must be able to see the screw heads of the box through the holes in the foam

    번역하기

  23. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 23 단계, 이미지 1/1

    • Insert box(53) and foam (58) into the housing(47). Make sure the foam is spread out evenly.

    번역하기

  24. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 24 단계, 이미지 1/1

    • Pull the protective backing off the adhesive tape and stick on foam(59). Use the crosses as a positioning aid.

    번역하기

  25. SOMNOcomfort and SOMNObalance Ventilator Fan Replacement: 25 단계, 이미지 1/1

    • Apply a small amount of 70% Isopropanol solution on the decoupling tube’s (50) circumference and attach it to the box. The tube’s notch must completely lock into the bore hole rim.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 1명과 함께

Diya Jamwal

회원 가입일: 11/07/18

553 평판

안내서 3개 작성하였습니다

배지: 5

배지 +2개 더

팀

Cal Poly, Team S1-G3, Zimmerman Spring 2020 Cal Poly, Team S1-G3, Zimmerman Spring 2020 회원

CPSU-ZIMMERMAN-S20S1G3

5 회원들

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 119