SOMNOcomfort and SOMNObalance Ventilator Filter Replacement - iFixit 수리 안내서

소개

Reference page 11 from the Service and Repair Instructions under Documents on the Main Page.

1 단계 Filter

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement, Filter: 1 단계, 이미지 1/1

Locate the Filter Compartment on the back of the ventilator.

2 단계

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: 2 단계, 이미지 1/1

Push the compartment cover (22) up (from the bottom)

3 단계

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: 3 단계, 이미지 1/1

Remove the coarse dust filter(68)

4 단계

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: 4 단계, 이미지 1/1

Remove the fine dust filter(67)

5 단계

Replace the filters and close the cover on the rear of the unit.

6 단계

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: 6 단계, 이미지 1/1

Reset the filter change indicator by pressing and holding the on/off switch(19) until the filter change indicator goes blank.
If the fine filter was changed due to soiling before 250 operating hours, the hours meter must be reset to zero. Proceed as follows:
When switching the unit on, press and hold the on/off switch 19. The filter change indicator will come on after about three seconds before going off again after another three seconds. Release the on and off switch.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 1명과 함께

Diya Jamwal

회원 가입일: 11/07/18

553 평판

안내서 3개 작성하였습니다

배지 +2개 더

팀

Cal Poly, Team S1-G3, Zimmerman Spring 2020 Cal Poly, Team S1-G3, Zimmerman Spring 2020 회원

CPSU-ZIMMERMAN-S20S1G3

5 회원들

안내서 10개 작성하였습니다

댓글 0개

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 3

전체 시간: 118