소개

Use this guide to replace the back casing and to remove the back casing to access the interior of the phone.

Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone. Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone. Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.
  • Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.

댓글 쓰기

Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone. Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone. Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.
  • Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Use the spudger to pry the two plastic caps out of the top corners of the phone casing. To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.
  • Use the spudger to pry the two plastic caps out of the top corners of the phone casing.

  • To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.

댓글 쓰기

Remove the six 4.0 mm screws using the Phillips 00 screwdriver.
  • Remove the six 4.0 mm screws using the Phillips 00 screwdriver.

댓글 쓰기

Insert the plastic opening tool in the gap between the back panel and rest of the body. Slide the tool along the edges until the two pieces come apart. The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.
  • Insert the plastic opening tool in the gap between the back panel and rest of the body.

  • Slide the tool along the edges until the two pieces come apart.

  • The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Ryan Rumsey

회원 가입일: 2013년 01월 30일

8 평판

안내서 6개 작성하였습니다

Cal Poly, Team 20-1, Maness Winter 2013 Cal Poly, Team 20-1, Maness Winter 2013 회원

CPSU-MANESS-W13S20G1

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 239