필요한 것
-
-
Remove the back cover of phone by lifting up on the back cover tab with the blue plastic opening tool.
-
Go around the edge of the back cover to completely remove it.
-
-
-
Remove the old battery by lifting up on the thumb tab.
-
Periodically clean the brass terminals on the battery and the phone. Place a minute amount of ISO on a Q-tip and gingerly clean the connections.
-
-
-
Remove the nine 4mm screws screws from the midframe with a Phillips #000 screwdriver.
-
-
-
-
Disconnect all flex cables and remove the motherboard and the front-facing camera.
-
The display assembly is attached to the frame with adhesive.
-
Insert an opening pick between the glass and the frame in the gap above the front-facing camera bracket. Begin to slice through the adhesive on the top bezel of the phone.
-
-
-
On the right corner, gently twist the pick up and down to further separate the adhesive, then insert it as shown between the LCD and the frame.
-
Insert a second pick into the gap between the frame and the display flex cable.
-
Move both picks towards the bottom of the phone to separate the adhesive on the sides of the screen.
-
-
-
Separate the adhesive on the bottom half of the phone, flip it around, and separate the frame from the screen assembly starting from the bottom.
-
Ensure the display cable can freely move through the hole in the frame.
-
-
-
The LCD and digitizer are not glued together with LOCA glue, but just with adhesive around the edges of the digitizer.
-
The digitizer is connected to the LCD with a flex cable. Flip up the bottom half of the connector.
-
Apply gentle heat to the IC. Insert a pick as shown and separate.
-
To separate the LCD and digitizer, apply gentle heat to the front of the assembly and gently slide picks along the edges of the LCD.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 6명이 해당 안내서를 완성하였습니다.
