주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

Prereq to remove the motherboard from the interior midframe.

부품

지정된 부품이 없습니다.

  1. Carefully wedge the tip of a spudger underneath the antenna cable connector. Delicately lift the spudger directly upwards to disconnect the antenna connector off its socket on the motherboard.
    • Carefully wedge the tip of a spudger underneath the antenna cable connector.

    • Delicately lift the spudger directly upwards to disconnect the antenna connector off its socket on the motherboard.

    • Some models have two antenna cables (blue and grey/white). Remove both of the cables.

  2. Remove the single 3.0 mm Phillips #000 screw securing the motherboard to the midframe.
    • Remove the single 3.0 mm Phillips #000 screw securing the motherboard to the midframe.

  3. Pull, but do not remove, the camera end of the motherboard up from the midframe to allow access to the connectors on the rear. Do not attempt to fully remove the motherboard as it is still attached to the interior midframe by the Micro-USB port daughterboard connector.
    • Pull, but do not remove, the camera end of the motherboard up from the midframe to allow access to the connectors on the rear.

    • Do not attempt to fully remove the motherboard as it is still attached to the interior midframe by the Micro-USB port daughterboard connector.

  4. Use the flat end of a spudger to pry the daughterboard connector straight up off its socket on the motherboard. Use the flat end of a spudger to pry the daughterboard connector straight up off its socket on the motherboard.
    • Use the flat end of a spudger to pry the daughterboard connector straight up off its socket on the motherboard.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Sam Goldheart

회원 가입일: 2012년 10월 18일

423,216 평판

안내서 547개 작성하였습니다

iFixit iFixit 회원

Community

132 회원들

안내서 13,017개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 2

전체 시간: 323