주요 콘텐츠로 건너뛰기

Samsung Galaxy Tab 4 10.1 Digitizer Replacement

필요한 것

  1. Samsung Galaxy Tab 4 10.1 Digitizer Replacement, Battery: 1 단계, 이미지 1/2 Samsung Galaxy Tab 4 10.1 Digitizer Replacement, Battery: 1 단계, 이미지 2/2
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 2 단계, 이미지 1/1
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 3 단계, 이미지 1/1
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 4 단계, 이미지 1/1
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  5. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 5 단계, 이미지 1/1
    • Use the nylon spudger to remove the battery by prying up on the edges.

  6. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 6 단계, 이미지 1/1
    • Once the battery is loose, lift it out of the device.

  7. Samsung Galaxy Tab 4 10.1 Digitizer Replacement, Digitizer: 7 단계, 이미지 1/1
    • Use the flat end of a spudger to disconnect the home button.

  8. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 8 단계, 이미지 1/1
    • Use an iOpener to weaken the adhesive around the display.

  9. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 9 단계, 이미지 1/1
    • Wedge an opening pick between the digitizer and display frame.

    • Slide the opening pick around the perimeter to separate the two pieces.

  10. Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 10 단계, 이미지 1/2 Samsung Galaxy Tab 4 10.1 Digitizer Replacement: 10 단계, 이미지 2/2
    • Lift and remove the digitizer.

결론

To reassemble your device, follow these instructions in reverse order.

다른 7명이 해당 안내서를 완성하였습니다.

Blake Klein

회원 가입일: 01/29/17

70,356 평판

안내서 50개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 1

30일 전: 16

전체 시간: 3,743