소개

Replacement guide for the power and volume buttons on a Samsung Galaxy Tab 4 10.1 android tablet.

The battery only needs to be disconnected—skip steps 2, 3, 5, and 6.

  1. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off. Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. Peel off the green tape that covers the connectors for the three black strips.
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. Use a Phillips #00  screwdriver to remove the four 3.2mm  screws.
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  5. Detach the red, blue, and black cables by prying up on the white connector from the motherboard.
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  6. Use the nylon spudger to remove the battery by prying up on the edges.
    • Use the nylon spudger to remove the battery by prying up on the edges.

  7. Once the battery is loose,  lift it out of the device.
    • Once the battery is loose, lift it out of the device.

  8. Pry up and disconnect the power and volume button press-fit connector with the flat end of a spudger. Pry up and disconnect the power and volume button press-fit connector with the flat end of a spudger.
    • Pry up and disconnect the power and volume button press-fit connector with the flat end of a spudger.

  9. Remove the power and volume button ribbon cable.
    • Remove the power and volume button ribbon cable.

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Blake Klein

회원 가입일: 2017년 01월 29일

42,055 평판

안내서 48개 작성하였습니다

iFixit iFixit 회원

Community

108 회원들

안내서 8,295개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 7

지난 30일: 41

전체 시간: 340