기기를 수리하세요 커뮤니티 상점

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

Samsung S85 Rubber Door Replacement

소개

This guide will show a user how to take off the rubber door for replacement.

필요한 것

  1. Samsung S85 Rubber Door Replacement, Rubber Door: 1 단계, 이미지 1/3 Samsung S85 Rubber Door Replacement, Rubber Door: 1 단계, 이미지 2/3 Samsung S85 Rubber Door Replacement, Rubber Door: 1 단계, 이미지 3/3

    • Remove 4 screws from bottom of camera

    • Remove 2 screws from side of camera

    • Remove 2 screws from side of camera

    • Place Screws on magnetic surface or location where they will not roll away

    번역하기

  2. Samsung S85 Rubber Door Replacement: 2 단계, 이미지 1/1

    • Squeeze area noted by blue square and pull outside shell apart from remaining camera.

    번역하기

  3. Samsung S85 Rubber Door Replacement: 3 단계, 이미지 1/2 Samsung S85 Rubber Door Replacement: 3 단계, 이미지 2/2

    • Remove 6 screws identified by red circles

    • Remove 3 screws identified by orange circles

    번역하기

  5. Samsung S85 Rubber Door Replacement: 4 단계, 이미지 1/2 Samsung S85 Rubber Door Replacement: 4 단계, 이미지 2/2

    • Gently remove orange circuit ribbon identified by red square

    • Gently remove narrow orange circuit ribbon identified by blue square

    번역하기

  6. Samsung S85 Rubber Door Replacement: 5 단계, 이미지 1/3 Samsung S85 Rubber Door Replacement: 5 단계, 이미지 2/3 Samsung S85 Rubber Door Replacement: 5 단계, 이미지 3/3

    • Be very cautious when using a soldering iron (they are on average 300 F)

    • Using a soldering iron, remove solder from wire identified by red circle

    • Using a soldering iron, remove solder from black and red wire identified by orange circle

    • Using a soldering iron, remove solder from wire identified by yellow circle

    번역하기

  7. Samsung S85 Rubber Door Replacement: 6 단계, 이미지 1/3 Samsung S85 Rubber Door Replacement: 6 단계, 이미지 2/3 Samsung S85 Rubber Door Replacement: 6 단계, 이미지 3/3

    • Using soldering iron, melt away solder and warm up metal located at top of circuit board as shown in picture

    • Repeat step two to three times until board feels flexible to bend

    • Slowly bend circuit board upwards (towards power button) until at 90 degree angle with remaining part of camera.

    번역하기

  8. Samsung S85 Rubber Door Replacement: 7 단계, 이미지 1/1

    • Remove black rubber door located on side of camera closest to lens using tweezers.

    • Be careful not to bend or tear the rubber when pulling out with tweezers as it may become difficult to put back in

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 2명과 함께

Avinash Salgam

회원 가입일: 02/16/14

597 평판

안내서 5개 작성하였습니다

배지: 7

배지 +4개 더

팀

University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014 University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014 회원

UICU-SCROGUM-S14S1G4

4 회원들

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 1

30일 전: 2

전체 시간: 263