주요 콘텐츠로 건너뛰기

Sanyo VPC-T700 LCD Screen Replacement

필요한 것

  1. Sanyo VPC-T700 LCD Screen Replacement, LCD Screen: 1 단계, 이미지 1/3 Sanyo VPC-T700 LCD Screen Replacement, LCD Screen: 1 단계, 이미지 2/3 Sanyo VPC-T700 LCD Screen Replacement, LCD Screen: 1 단계, 이미지 3/3
    • Cameras powers on and the broken LCD becomes immediately evident.

    • Remove the battery

    • Remove the camera strap

  2. Sanyo VPC-T700 LCD Screen Replacement: 2 단계, 이미지 1/3 Sanyo VPC-T700 LCD Screen Replacement: 2 단계, 이미지 2/3 Sanyo VPC-T700 LCD Screen Replacement: 2 단계, 이미지 3/3
    • Remove the four screws on the right side of the camera

    • Remove the two screws on the left side.

    • remove the four screws on the bottom of the camera.

    • The two screws on the thread for a tripod are longer than the others, keep those separated.

  3. Sanyo VPC-T700 LCD Screen Replacement: 3 단계, 이미지 1/3 Sanyo VPC-T700 LCD Screen Replacement: 3 단계, 이미지 2/3 Sanyo VPC-T700 LCD Screen Replacement: 3 단계, 이미지 3/3
    • Here is a look at the screws from the camera. The two screws from the tripod thread are the longest.

    • Start splitting the housing with either an opening tool or your fingernails. The housing does not require a lot of force and will easily unsnap.

    • The front cover seems to be easiest and will come off first

  4. Sanyo VPC-T700 LCD Screen Replacement: 4 단계, 이미지 1/3 Sanyo VPC-T700 LCD Screen Replacement: 4 단계, 이미지 2/3 Sanyo VPC-T700 LCD Screen Replacement: 4 단계, 이미지 3/3
    • The rear cover can now be easily removed. The LCD is sitting in a frame without fasteners. It will just lift up, however, there will be a piece of insulating material that is separating the back of the LCD from the logic board. Remove this after the removal of the LCD from the frame. Do not try to remove the LCD from the PCB yet.

    • Open the ribbon cable connector by pulling the white clasp gently up.

    • Remove the old LCD.

  5. Sanyo VPC-T700 LCD Screen Replacement: 5 단계, 이미지 1/2 Sanyo VPC-T700 LCD Screen Replacement: 5 단계, 이미지 2/2
    • Here is the new LCD. Note the protective cover. Remove that cover by pulling on the green tab after installing the LCD to the PCB.

    • After reassembling your camera, hopefully it will look like this.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

oldturkey03

회원 가입일: 09/29/10

782,246 평판

안내서 119개 작성하였습니다

Global Fixers Global Fixers 회원

Community

33 회원들

안내서 537개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 4

전체 시간: 1,294