소개

This guide will help you remove the button plate from the camera

부품

부품은 필요하지 않습니다.

Remove the five case screws with a Phillips #00 Screwdriver.
  • Remove the five case screws with a Phillips #00 Screwdriver.

  • Five 3.5mm Phillips Screws

댓글 쓰기

Gently lift up the back cover and set aside.
  • Gently lift up the back cover and set aside.

댓글 쓰기

  • Gently lift up on the left side of the LCD and slowly pull it to the left side of the camera but do not remove entirely, there is a ribbon connector.

  • Be careful not to rip out the ribbon connector.

댓글 쓰기

  • To clear the ribbon connection underneath the screen, lift up the black ribbon gate with the spudger.

  • Gently lift ribbon out of the gate and set screen aside.

댓글 쓰기

  • There are five screws of three different sizes which need removal.

  • One 4.5mm screw

  • Four 3.5mm screws, one on the button side

  • One 5.5mm screws

댓글 쓰기

  • Slowly lift metal tray to the right.

  • Be careful not to bend the screw tabs or rip out the ribbon cable.

  • Remove ribbon cable by using the spudger to lift up the black ribbon gate to release the ribbon

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Anthony Giardina

회원 가입일: 2010년 04월 19일

20 평판

안내서 7개 작성하였습니다

Cal Poly, Team 7-10, Maness Spring 2010 Cal Poly, Team 7-10, Maness Spring 2010 회원

CPSU-MANESS-S10S7G10

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 1

전체 시간: 2,098