부품

부품은 필요하지 않습니다.

Place the monitor face down.
  • Place the monitor face down.

  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the stand by pulling it out.

댓글 쓰기

Remove two 11.5mm screws with a  #2 Phillips screwdriver.
  • Remove two 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the plastic bar.

댓글 쓰기

  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

댓글 쓰기

  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

  • Once all the clips have been released, remove the cover by pulling it up.

댓글 쓰기

  • Using the #2 Phillips screwdriver, remove the one 6mm screw.

  • Unplug the indicated cable by pulling on the base.

  • Slide the cover toward the top of the monitor.

  • Remove the cover.

댓글 쓰기

  • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

댓글 쓰기

  • Carefully peel the tape from the board.

댓글 쓰기

  • Flip the monitor so the screen is facing you.

  • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

댓글 쓰기

  • Carefully lift the speakers up.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Xenia Leon Rodriguez

회원 가입일: 2012년 09월 26일

37 평판

안내서 1개 작성함

Cal Poly, Team 16-56, Forte Fall 2012 Cal Poly, Team 16-56, Forte Fall 2012 회원

CPSU-FORTE-F12S16G56

5 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 315