소개

A guide to installing a replacement screen on a Sega Game Gear.

부품

부품은 필요하지 않습니다.

Place your device upside down and locate the two battery compartments.
  • Place your device upside down and locate the two battery compartments.

댓글 쓰기

Press on the tabs at the bottom of the battery covers then lift up to remove.
  • Press on the tabs at the bottom of the battery covers then lift up to remove.

  • Remove batteries if they are present.

댓글 쓰기

  • Remove the following screws:

    • Seven Phillips scres

    • One 4.5 mm Gamebit screw

댓글 쓰기

  • Use tweezers to take all other screws out.

댓글 쓰기

  • Gently open the case by unfolding it over the top of the Sega Game Gear.

  • Do not pull the back of the case away, as cables are connected between both sides.

댓글 쓰기

  • Carefully unplug the 2 white-tipped connectors on the top cover.

댓글 쓰기

  • Unscrew all the marked screws.

댓글 쓰기

  • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

댓글 쓰기

  • Place the board onto a flat surface.

  • Small plastic buttons may fall off during this process, save them in a container or a place where they could be found later on.

댓글 쓰기

  • Unscrew the marked screws.

  • Flip the board, having its back facing up.

  • Hold onto the screen in the back, as it will flip open if not held onto.

댓글 쓰기

  • Make sure the screen is towards the bottom, as indicated in the second picture.

댓글 쓰기

  • Gently open the screen up.

  • The screen will not come out all the way since it is glued onto the top side.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 8명이 해당 안내서를 완성하였습니다.

Lauren Thurston

회원 가입일: 2010년 04월 15일

296 평판

안내서 3개 작성하였습니다

Cal Poly, Team 28-33, Regan Spring 2010 Cal Poly, Team 28-33, Regan Spring 2010 회원

CPSU-REGAN-S10S28G33

5 회원들

안내서 6개 작성하였습니다

any one know where to get a new display that wont bleed me dry?

isaiah bellamy (masta ike) - 답글

Due to the nature a Game Gear screen attaches, a ribbon directly soldered to the mainboard, replacing it requires a soldering iron and some fairly advanced technique.

This guide, titled “Sega Game Gear Screen Replacement”, only takes us to the point you remove the ribbon. There is much work left.

Anthony Bessel - 답글

so, uh, is there a more comprehensive version somewhere?

rollin -

댓글 쓰기

조회 통계:

지난 24시간: 14

지난 7일: 55

지난 30일: 344

전체 시간: 40,016