소개

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

부품

부품은 필요하지 않습니다.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

  3. Gently lift the top casing.
    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

  4. Bend out the LED leads into vertical positions.
    • Bend out the LED leads into vertical positions.

  5. US$100.00 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  6. Slide the LED wire apparatus off the lead pins.
    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

  7. Separate the main board from the outer case.
    • Separate the main board from the outer case.

  8. Using Philips screwdriver, remove 11 screws securing silver casing.
    • Using Philips screwdriver, remove 11 screws securing silver casing.

  9. Remove silver case.
    • Remove silver case.

  10. Locate reset button on motherboard
    • Locate reset button on motherboard

  11. Place three pieces of 1cm x 1cm masking tape over reset button.
    • Place three pieces of 1cm x 1cm masking tape over reset button.

결론

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

다른 한 분이 해당 안내서를 완성하였습니다.

calvin

회원 가입일: 2010년 10월 05일

195 평판

안내서 1개 작성함

Cal Poly, Team 3-29, Regan Fall 2010 Cal Poly, Team 3-29, Regan Fall 2010 회원

CPSU-REGAN-F10S3G29

4 회원들

안내서 5개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 16

지난 30일: 95

전체 시간: 11,776