부품

부품은 필요하지 않습니다.

Place the TV face down on a flat smooth surface as to not scratch the screen.
  • Place the TV face down on a flat smooth surface as to not scratch the screen.

  • Remove the four 8mm screws attaching the stand to the TV.

댓글 쓰기

Lift the stand off the television.
  • Lift the stand off the television.

댓글 쓰기

  • Remove the two back panels to display the audio and video inputs..

댓글 쓰기

  • Remove the eight 6mm Phillips screws around the edge.

  • Remove the two 6mm Phillips near the inputs.

댓글 쓰기

  • Lift and remove the back case of the television.

댓글 쓰기

  • Remove the two speaker cables and the connector from the circuit board by pinching the plastic connectors and firmly pulling up.

  • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

댓글 쓰기

  • Remove the green and gray power connector from the side of the buttons panel at the top of the television.

  • Remove the green/gray to orange/gray connector from the center of the circuit board.

댓글 쓰기

  • Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case.

댓글 쓰기

  • Lift the circuit board/LCD block from the case by lifting the near side of the circuit board and sliding it under the button frame.

댓글 쓰기

  • Flip the LCD/circuit board so that the circuit board faces up.

댓글 쓰기

  • Remove the three 5mm Philips screws attaching the circuit board to the LCD.

  • Remove the five 6mm Phillips screws from the edges of the circuit board attacking it to the LCD.

댓글 쓰기

  • Turn the circuit board so the blue and pink side cables are facing you.

  • Hold the white plastic, squeeze and pull from the sides.

  • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

댓글 쓰기

  • Turn the television so the right hand side is facing you.

  • To remove the ribbon cables, fold the brown casing down and pull directly upward on the ribbon.

  • Turn the television so the left hand side is facing you, and remove the ribbon cable in the same manner.

댓글 쓰기

  • Turn the circuit board so that the left side is facing you.

  • Detach the data cable from the circuit board.

  • To do this, slide your finger nail from the middle of the connector until the little black tabs rotates down toward the board as shown in the second picture.

댓글 쓰기

  • Lift and remove the circuit board from the LCD frame.

댓글 쓰기

  • Now you have your LCD.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Robert Hobson

회원 가입일: 2011년 01월 20일

1,275 평판

안내서 9개 작성하였습니다

Cal Poly, Team 1-11, Amido Winter 2011 Cal Poly, Team 1-11, Amido Winter 2011 회원

CPSU-AMIDO-W11S1G11

4 회원들

안내서 9개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 5

지난 7일: 16

지난 30일: 52

전체 시간: 6,614