주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

The control wheel is used to navigate through pictures, and can wear down over time, and will need replacement.

부품

지정된 부품이 없습니다.

  1. Turn the camera off by sliding the power switch.
    • Turn the camera off by sliding the power switch.

  2. Use a Phillips head 000 screwdriver to remove the 4.0mm screw inside the USB port.
    • Use a Phillips head 000 screwdriver to remove the 4.0mm screw inside the USB port.

  3. Use a Phillips head 000 screwdriver to remove the one 4.0mm screw on the side opposite of the USB port near the shutter button.
    • Use a Phillips head 000 screwdriver to remove the one 4.0mm screw on the side opposite of the USB port near the shutter button.

  4. Open the flap at the top of the camera. Use a Phillips head 000 screwdriver to remove the two 4.0mm screws inside.
    • Open the flap at the top of the camera.

    • Use a Phillips head 000 screwdriver to remove the two 4.0mm screws inside.

  5. Gently lift off the top panel with your hands.
    • Gently lift off the top panel with your hands.

  6. Use a Phillips head 000 screwdriver to remove the 4.0mm screw at the side opposite of the USB port.
    • Use a Phillips head 000 screwdriver to remove the 4.0mm screw at the side opposite of the USB port.

  7. Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera. Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera.
    • Use a Phillips head 000 screwdriver to remove the three 4.0mm screws on the bottom of the camera.

  8. Tilt up the LCD screen.
    • Tilt up the LCD screen.

    • Use a Phillips head 000 screwdriver to remove the two coarse 4.0mm screws near the bottom of the camera.

  9. Gently pry off the back panel, by wiggling it around the LCD screen.
    • Gently pry off the back panel, by wiggling it around the LCD screen.

  10. Tilt up the LCD screen. Grab the silver plate, and gently pry it up.
    • Tilt up the LCD screen.

    • Grab the silver plate, and gently pry it up.

  11. Gently pinch blue ribbon cable, and pull it out of the port. Gently pinch blue ribbon cable, and pull it out of the port.
    • Gently pinch blue ribbon cable, and pull it out of the port.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Jonathan Chen

회원 가입일: 2017년 10월 17일

645 평판

안내서 6개 작성하였습니다

UC Santa Barbara, Team S1-G1, Weedon Fall 2017 UC Santa Barbara, Team S1-G1, Weedon Fall 2017 회원

UCSB-WEEDON-F17S1G1

3 회원들

안내서 13개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 8

30일 전: 27

전체 시간: 1,615