소개

This guide will detail the steps necessary to remove the back cover of the Sony Bloggie 3D Player.

  1. Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
    • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

  2. Use a plastic opening tool to pry the cover open. After the the cover is partly open as shown, remove the cover with your hands.
    • Use a plastic opening tool to pry the cover open.

    • After the the cover is partly open as shown, remove the cover with your hands.

  3. US$100.00 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  4. Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board. Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.
    • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

  5. Use a plastic opening tool to loosen the back cover off the device. Once the back cover is loose, remove it gently by hand.
    • Use a plastic opening tool to loosen the back cover off the device.

    • Once the back cover is loose, remove it gently by hand.

결론

To reassemble your device, follow these instructions in reverse order.

Timothy Tran

회원 가입일: 2013년 01월 30일

1 평판

안내서 2개 작성하였습니다

Cal Poly, Team 7-12, Maness Winter 2013 Cal Poly, Team 7-12, Maness Winter 2013 회원

CPSU-MANESS-W13S7G12

5 회원들

안내서 6개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 279