소개

The following guide will walk you through the steps necessary to remove and replace your thumb dial.

부품

부품은 필요하지 않습니다.

  • First, place your device with the screen side facing down.

댓글 쓰기

On the back of the device, remove the 2 screws from the thumb dial panel, which is located on the upper right hand side.
  • On the back of the device, remove the 2 screws from the thumb dial panel, which is located on the upper right hand side.

댓글 쓰기

  • Remove the screw directly above the thumb dial panel.

댓글 쓰기

  • Remove the screw from thumb dial panel on the right handed side of the device.

댓글 쓰기

  • Remove screw from lower right side of the device.

댓글 쓰기

  • Remove 1 screw from the lower left side of the device.

댓글 쓰기

  • On the bottom of the device, remove both the left and right screws.

댓글 쓰기

  • Remove the thumb dial panel by sliding it away from the device.

댓글 쓰기

  • Remove the back panel exposing the inside of the device.

댓글 쓰기

  • Locate thumb dial on top right side of the board.

댓글 쓰기

  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

댓글 쓰기

  • Pull plug straight up to remove from board.

댓글 쓰기

  • Place plug back on board and push down on center to secure to board.

댓글 쓰기

  • Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Rob

회원 가입일: 2011년 10월 04일

1 평판

안내서 2개 작성하였습니다

UW Stout, Team 5-6, Zhou Fall 2011 UW Stout, Team 5-6, Zhou Fall 2011 회원

UWSTOUT-ZHOU-F11S5G6

4 회원들

안내서 2개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 3

지난 7일: 3

지난 30일: 18

전체 시간: 891