주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

소개

This guide will demonstrate how to replace the Memory Card Reader. This will fix the "Unable to read memory card" Error.

부품

지정된 부품이 없습니다.

  1. Use a Phillips #0 screwdriver to unscrew the six 2mm screws on the outer case of the camera. If there is a battery or SD card inside remove before beginning the process. If there is a battery or SD card inside remove before beginning the process.
    • Use a Phillips #0 screwdriver to unscrew the six 2mm screws on the outer case of the camera.

    • If there is a battery or SD card inside remove before beginning the process.

  2. Use your hands or a Spudger to Pull off the front cover of the camera. If the casing is not coming apart easily, do not force it.
    • Use your hands or a Spudger to Pull off the front cover of the camera.

    • If the casing is not coming apart easily, do not force it.

  3. Remove the protective black cover layer with your hands and set it aside.
    • Remove the protective black cover layer with your hands and set it aside.

    • The use of tweezers may be necessary if the cover is difficult to remove.

  4. The ZIF  connector can be removed by flipping the small black holder into the upright position and then sliding the ribbon cable out carefully. Once this has been done, use tweezers to unplug the flat topped connector for the lens’ circuit board from the motherboard.
    • The ZIF connector can be removed by flipping the small black holder into the upright position and then sliding the ribbon cable out carefully.

    • Once this has been done, use tweezers to unplug the flat topped connector for the lens’ circuit board from the motherboard.

    • DO NOT force the ribbon cables or they will rip.

    • Refer to the (케이블 커넥터 인식 및 분리) page for assistance.

  5. Using a Phillips head screw driver, remove the two screws for the metal plate on the bottom. Detach the smaller ribbon cables by  sliding them out. Detach the large ribbon cable by flipping the small black holder in an upright position and then sliding the cable out carefully.
    • Using a Phillips head screw driver, remove the two screws for the metal plate on the bottom.

    • Detach the smaller ribbon cables by sliding them out.

    • Detach the large ribbon cable by flipping the small black holder in an upright position and then sliding the cable out carefully.

    • Detach the ribbon cables slowly and carefully or they will rip.

  6. Carefully remove the Memory card circuit board. The circuit board should come out with little force. If it does not, make sure all connections are disconnected.
    • Carefully remove the Memory card circuit board.

    • The circuit board should come out with little force. If it does not, make sure all connections are disconnected.

결론

To reassemble your device, follow these instructions in reverse order.

Yegor Shea

회원 가입일: 2017년 03월 26일

301 평판

안내서 3개 작성하였습니다

UMass Dartmouth, Team S4-G3, Julie Spring 2017 UMass Dartmouth, Team S4-G3, Julie Spring 2017 회원

UMASSD-JULIE-S17S4G3

5 회원들

안내서 4개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 2

전체 시간: 207