주요 콘텐츠로 건너뛰기

Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

필요한 것

  1. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement, Outer Case: 1 단계, 이미지 1/1
    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 2 단계, 이미지 1/1
    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 3 단계, 이미지 1/1
    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 4 단계, 이미지 1/1
    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 5 단계, 이미지 1/1
    • Open the case as shown.

  6. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 6 단계, 이미지 1/1
    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  7. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 7 단계, 이미지 1/1
    • Pull the ribbon cable out.

  8. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement, Motherboard Assembly: 8 단계, 이미지 1/1
    • Remove all six screws on the front side of the motherboard circled in the picture.

    • Pull the motherboard from the rest of the housing.

    • It will still be connected to the flash unit.

  9. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 9 단계, 이미지 1/1
    • Remove the cable on the back side of the motherboard.

  10. Sony Cyber-shot DSC-P52 Motherboard Assembly Replacement: 10 단계, 이미지 1/1
    • Detach the ribbon cables shown.

    • Careful! Touching the leads of the large yellow capacitor can result in a painful shock.

    • Remove the flash unit from the motherboard.

결론

To reassemble your device, follow these instructions in reverse order.

Trevor

회원 가입일: 01/20/11

295 평판

안내서 6개 작성하였습니다

Cal Poly, Team 3-43, Regan Winter 2011 Cal Poly, Team 3-43, Regan Winter 2011 회원

CPSU-REGAN-W11S3G43

4 회원들

안내서 20개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 213