필요한 것
-
-
-
Using a spudger, wedge the flat tipped end between the black bar and the circuit board.
-
Carefully lift the black bar into the vertical position.
-
Repeat first two bullet points for the circuit board port directly to the left of the one shown in this picture.
-
Use tweezers to carefully pull the electrical ribbons from the circuit board ports.
-
거의 끝나갑니다!
To reassemble your device, follow these instructions in reverse order.
결론
To reassemble your device, follow these instructions in reverse order.
다른 2명이 해당 안내서를 완성하였습니다.