소개
This guide will allow the reader to how to disassemble the DSC-WX100 and get to its image sensor.
필요한 것
-
-
Remove all of the 1mm screws using a Philips #000 Screwdriver.
-
Remover the rest of the screws (2mm) from the camera covers using a Phillips #000 Screwdriver.
-
-
-
-
Pull up on the lower end of the plate. Lift it so that the plate is uninhibited by the indicated bump.
-
Pull away from the camera at the end of the metal plate with the blue circuits to then remove the plate from the rest of the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 2명이 해당 안내서를 완성하였습니다.
댓글 한 개
thanks a lot very helpfull.
could you precise( in remounting phase) that it is necessary to take care of the position of the back slider (photo/pano/video) before screwing, it will avoid to dismount again…….
regards