기기를 수리하세요 커뮤니티 상점

Sony Ericsson Xperia Play Digitizer Replacement

소개

A guide on how to replace the glass on a Sony Xperia Play.

필요한 것

  1. Sony Ericsson Xperia Play Digitizer Replacement, Digitizer: 1 단계, 이미지 1/1

    • Remove the 6 silver torx screws marked in red

    편집

  2. Sony Ericsson Xperia Play Digitizer Replacement: 2 단계, 이미지 1/1

    • Remove the 7 black torx screws marked in yellow.

    편집

  3. Sony Ericsson Xperia Play Digitizer Replacement: 3 단계, 이미지 1/1

    • Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.

    편집

  4. Sony Ericsson Xperia Play Digitizer Replacement: 4 단계, 이미지 1/1

    • Remove the plastic housing revealing the motherboard

    • Remove the two Phillips screws.

    편집

  6. Sony Ericsson Xperia Play Digitizer Replacement: 5 단계, 이미지 1/1

    • Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees

    편집

  7. Sony Ericsson Xperia Play Digitizer Replacement: 6 단계, 이미지 1/1

    • Slide the phone to the open position

    편집

  8. Sony Ericsson Xperia Play Digitizer Replacement: 7 단계, 이미지 1/1

    • Remove the display connector marked in orange using a plastic spudger to pry it upwards

    • Remove the connector for the front buttons by prising the retaining clip to 90 degrees

    편집

  9. Sony Ericsson Xperia Play Digitizer Replacement: 8 단계, 이미지 1/1

    • Remove motherboard

    편집

  10. Sony Ericsson Xperia Play Digitizer Replacement: 9 단계, 이미지 1/1

    • Remove the buttons from the phone

    편집

  11. Sony Ericsson Xperia Play Digitizer Replacement: 10 단계, 이미지 1/1

    • Remove the three Phillips screws.

    편집

  12. Sony Ericsson Xperia Play Digitizer Replacement: 11 단계, 이미지 1/1

    • Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw

    • Disconnect the digitizer cable

    편집

  13. Sony Ericsson Xperia Play Digitizer Replacement: 12 단계, 이미지 1/1

    • Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass

    • Using a heat gun heat around the edges of the glass to soften the glue, and use your prying tool between the glass and the frame to take the glass off.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 16명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Kris James

회원 가입일: 01/27/12

603 평판

안내서 1개 작성함

배지: 9

배지 +6개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 1

7일 전: 3

30일 전: 11

전체 시간: 31,332