Skip to main content

소개

How to change the Main Flex / Ribbon cable.


Please SUBSCRIBE to my channel ツ

동영상 개요

  1. Remove the battery cover and the battery. You have 6x silver screw and 7x black screw and remove the rear bezel. You have 6x silver screw and 7x black screw and remove the rear bezel.
    • Remove the battery cover and the battery.

    • You have 6x silver screw and 7x black screw and remove the rear bezel.

  2. Now with a plastic tool disconnect the main flex cable. Be careful, near to the main flex cable connector there is many small elements. Disconnect the gaming keyboard flex keyboard.
    • Now with a plastic tool disconnect the main flex cable. Be careful, near to the main flex cable connector there is many small elements.

    • Disconnect the gaming keyboard flex keyboard.

  3. Remove the mother board and the gaming keyboard. Remove the mother board and the gaming keyboard.
    • Remove the mother board and the gaming keyboard.

  4. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  5. Unscrew the 4x screws. Remove the black sticker. Disconnect the touchscreen flex cable connector.
    • Unscrew the 4x screws.

    • Remove the black sticker.

    • Disconnect the touchscreen flex cable connector.

    • Now you can disassemble the front bezel.

  6. Use the thin end of a plastic tool to remove LCD Display and disconnect the flex cable. Use the thin end of a plastic tool to remove LCD Display and disconnect the flex cable.
    • Use the thin end of a plastic tool to remove LCD Display and disconnect the flex cable.

  7. To release the ribbon cable peel off two patches. To release the ribbon cable peel off two patches. To release the ribbon cable peel off two patches.
    • To release the ribbon cable peel off two patches.

  8. Now remove the small metal plate taped to the flex cable. Remove the plastic plate from the back side of the flex cable connector. Bend the cable at an angle so you can push it down through the hole.
    • Now remove the small metal plate taped to the flex cable.

    • Remove the plastic plate from the back side of the flex cable connector.

    • Bend the cable at an angle so you can push it down through the hole.

  9. Use the same technique when you are installing the new Main Ribbon Cable. I prefer to test the new spare part before the full assembly. I prefer to test the new spare part before the full assembly.
    • Use the same technique when you are installing the new Main Ribbon Cable.

    • I prefer to test the new spare part before the full assembly.

  10. That's all.
결론

To reassemble your device, follow these instructions in reverse order.

다른 4명이 해당 안내서를 완성하였습니다.

ZFix

회원 가입일: 2013년 12월 09일

164,078 평판

안내서 305개 작성하였습니다

Master Techs Master Techs 회원

Community

286 회원들

안내서 808개 작성하였습니다

Iv got a problem my phone won't turn on or charge but when i plug the charger in the power button just flashes red a couple of times then nothing do u know what this means is it the battery or the phone that is broke

paulfrost412 - 답글

Is "small metal plate" from Step 7 important? Forgot to put it inside and if there is no need to open it again (everything works) I won't do it :)

ch3mn3y - 답글

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 9

지난 30일: 291

전체 시간: 5,245