주요 콘텐츠로 건너뛰기

What you need

  1. Sony SRS-X3 Speakers Replacement, Speakers: 1 단계, 이미지 1/1
    • Remove rubber feet on the bottom of the device

  2. Sony SRS-X3 Speakers Replacement: 2 단계, 이미지 1/1
    • Remove 6 silver philips head screws with PH1 bit

    • Remove bottom plastic cover of speaker

  3. Sony SRS-X3 Speakers Replacement: 3 단계, 이미지 1/1
    • Remove 2 phillips head screws holding battery pack with PH1 bit

    • Remove battery back with spudger

  4. Sony SRS-X3 Speakers Replacement: 4 단계, 이미지 1/1
    • Unscrew 3 phillips head screws using PH1 bit

    • Remove green board. Battery pack and green circuit board should still be connected to the speaker by a ribbon wire. This is normal.

  5. Sony SRS-X3 Speakers Replacement: 5 단계, 이미지 1/2 Sony SRS-X3 Speakers Replacement: 5 단계, 이미지 2/2
    • Pop off front speaker face (dark grey with little holes) by pushing out 3 tabs where screws were previously located and sticking spudger in crack where grey speaker face meets the outer shell

    • You may really have to pry on this part, it is not easy to remove and will pop out when released

  6. Sony SRS-X3 Speakers Replacement: 6 단계, 이미지 1/1
    • Remove 8 black phillips head screws shown with PH1 bit

  7. Sony SRS-X3 Speakers Replacement: 7 단계, 이미지 1/2 Sony SRS-X3 Speakers Replacement: 7 단계, 이미지 2/2
    • Remove front face by prying 2 black tabs shown using spudger

    • This face is glued in and may need some elbow grease to remove. Don't worry about breaking anything, as it is all connected

  8. Sony SRS-X3 Speakers Replacement: 8 단계, 이미지 1/1
    • Remove speaker wires from each speaker (2 wires per speaker) and take speakers out of device

    • Speaker wire connectors are made to connect very snug, so they should be hard to remove. Give it a good tug and they should pop off the male end

  9. Sony SRS-X3 Speakers Replacement: 9 단계, 이미지 1/1
    • You can now replace your speakers and reassemble this unit. If replacing the mother board continue with steps 10-14 in the mother board repair guide.

결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

Andrew Troyer

회원 가입일: 2017년 01월 17일

309 평판

안내서 2개 작성하였습니다

Team

4 Comments

Where would I get the new speakers from tho? Thanks a lot

Ruben Götz - 답글

Where I can buy one speaker as a spare part?

Karim Karimov - 답글

I would also like to know where I can get a replacement speaker

Aaron Todd - 답글

This SRS X3 cannot be used with the dc in 5v plugged, how can i do to make it work continuously with the charge cable? It have to be hacked? thanks

carlos cesar quan - 답글

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 10

30일 전: 29

전체 시간: 2,083