Sony SRS-X3 Speakers Replacement

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

소개

On this guide, the aim is to teach how to disassemble the Sony SRS-X3 bluetooth speaker in order to replace the speakers in the unit. This teardown is fairly simple, and only requires two tools. This speaker replacement is being completed because of a humming sound coming from the unit when music is being played.

필요한 것

1 단계 Speakers

Sony SRS-X3 Speakers Replacement, Speakers: 1 단계, 이미지 1/1

Remove rubber feet on the bottom of the device

번역하기

2 단계

Remove 6 silver philips head screws with PH1 bit
Remove bottom plastic cover of speaker

번역하기

3 단계

Remove 2 phillips head screws holding battery pack with PH1 bit
Remove battery back with spudger

번역하기

4 단계

Unscrew 3 phillips head screws using PH1 bit
Remove green board. Battery pack and green circuit board should still be connected to the speaker by a ribbon wire. This is normal.

번역하기

5 단계

Pop off front speaker face (dark grey with little holes) by pushing out 3 tabs where screws were previously located and sticking spudger in crack where grey speaker face meets the outer shell
You may really have to pry on this part, it is not easy to remove and will pop out when released

번역하기

6 단계

Remove 8 black phillips head screws shown with PH1 bit

번역하기

7 단계

Remove front face by prying 2 black tabs shown using spudger
This face is glued in and may need some elbow grease to remove. Don't worry about breaking anything, as it is all connected

번역하기

8 단계

Remove speaker wires from each speaker (2 wires per speaker) and take speakers out of device
Speaker wire connectors are made to connect very snug, so they should be hard to remove. Give it a good tug and they should pop off the male end

번역하기